Home - Toolauth/wing-combo GitHub Wiki

[!IMPORTANT] This Wiki describes the wing-combo board only.

For more information about the Toolauth project in general, visit the main site.

This Combined Use Feather Wing board is the main flagship of the Toolauth project. It is designed to be a compliant Adafruit Feather Wing so that any microcontroller that is also compliant with the Feather specification may act as the processing unit and provide network communication.

The circuit board can:

• control power to a tool with relays and a contactor
• measure the electrical current used by the tool
• Easily add an RFID card reader for authorization
• Power itself off the connected tool's power supply
• Communicate via WiFi, using the central Feather

More information needed for use:

• Required external, End User Controls
• Basic Breakdown of Standard Use
• Overview of Firmware, hello-world and more
• Set-Up guide for the board in a controller box

This board was designed at and for MakeHaven. A nonprofit community Fab Lab, Makerspace, workshop in New Haven, Connecticut, USA. A small team of dedicated members and employees worked together to design these boards based on knowledge gained from a legacy system that was in place.