FAQ - The-Hybrid-Atelier/RheoBoard GitHub Wiki

Answers for RheoBoardOTS - DIY point at the page that owns the step.

Do I need soldering, CAD, or a custom PCB?

See the assembly instructions. Basic soldering is not required if the boards already have headers and the actuator leads are prepared. You need Arduino IDE familiarity and the ability to read a wiring diagram. RheoBoardOTS - DIY does not require CAD or a custom PCB. RheoBoard_v1 - PCB is separate.

Where are the parts, design files, and software?

RheoBoardOTS - DIY parts are on Parts to buy and Parts to 3D print. Firmware is on Firmware. RheoData is on Software.

What tools does the build guide name?

See Tools you may need.

How is the panel assembled?

See Step 01: Mount the components.

What has to be true before power is applied?

See Step 02: Connect electronics and check wiring and Step 03: Connect tubing. Both stay unpowered.

How does the power-on test proceed?

See Step 05: Check power and idle behavior.

Which sketch is uploaded?

See Install on the Firmware page. Assembly Step 04 sends the RheoBoardOTS - DIY route there. RheoData is on Software.

How do I calibrate and measure?

See Step 06: Read pressure. That step is one pressure reading in Serial Monitor. It is not a calibration. A defined pass/fail calibration is not in this guide yet.

What tools are required beyond the build guide?

See Tools you may need.