Shifter Instructions - PADME-Experiment/padme-fw GitHub Wiki
Anybody who has to do shifts please look at the List of users enabled to the new DCS control (updated to 12/10/2020) and check his/her userid/password to enter the new DCS control system please. If you are not on the list, please ask Venelin to add him/her.
- Running the DAQ
- List of users enabled to the new DCS control
- How to fill the ELOG
- Numbers to be called
- Clean-up Procedure
- DAQ Troubleshooting
- New DCS monitor
- Reset VME crates
- Reset NIM crates and Vetos
- Trigger distribution problems
- ECAL map
- TARGET map
- Check ECAL/SAC HV
- Switch ON/OFF ECAL
- Diamond and Mimosa step motors - how to
- Target and Mimosa Position - Target Monitoring
- Target HV/LV setup and monitor with old DCS
- Lumi CALO setup and monitor with old DCS
- Sofia DCS start and stop infos
- PadmeMonitor guide
- Run list
- Set up to its standard value one single HV channel
- ECAL Temperature readout
- Guide for remote shifters
- NEW - MicroMegas chamber operation
- NEW - MicroMegas chamber monitor
- NEW ‐ MicroMegas DAQ instructions
- NEW - TMM chamber operation
- NEW ‐ How to control Target motor ‐ Run IV
OLD Items - not anymore in use
- Reset VME crates (old)
- Reset NIM crate (old)
- Check ECAL/SAC HV (old)
- Fixing tripped channel on ECAL (old)
- HV automatically set for all the ECAL channels (old)
- DCS alarm on shifter console
- Diamond Target GUIDE (obsolete)
- Data acquisition of Timepix3
- Timepix hard reset
- Timepix manual
- Restart Reco online, RecoMonitor and trends
- How to restart the DAQ status monitor in DCS summary page
- How to restart the monitor
- NEW : DHSTB01 magnetic field camera
- NEW Timepix manual
- Setup vetos
- MIMOSA operation
- SAC map
- Switch ON/OFF SAC