Target and Mimosa Position Target Monitoring - PADME-Experiment/padme-fw GitHub Wiki

---

Target and Mimosa position

---

At the moment no feedback for the target position is available, except the Webcam monitor (see instructions for the motor movement).

Target and Mimosa on beam, nominal position :

Target
5.2 cm on the ruler (MAX value 5.3 cm)

Mimosa
9.2-9.3 cm on the ruler (MAX value 9.5 cm)

Please now for the movement of the Target use the webcam feedback.

Here a picture in which both of the detectors are on beam. http://www.le.infn.it/padme/forWEB/TargetMimosaOnBeam.png

Here a picture in which both of the detectors are out of beam:

---

Target High Voltage and Low Voltage Values

---

The LV voltage must be under 5 V, with a current of max 0.2 A.
The HV voltage for this runs is at -250 V, with a current of few umA.

---

(old) In the section DCS, in the online monitor, a feedback of the position of Target and Mimosa online is available (MAX value is the MAX position before the mechanical stop (a screw).