RheoBoardOTS - The-Hybrid-Atelier/RheoBoard GitHub Wiki

The current DIY hardware is the flat 3D-printed panel.

RheoBoardOTS - DIY uses two air pumps, one valve, an ESP32 with BLE, and a Qwiic MicroPressure sensor. On command, it runs a REP (What is REP?) and streams the pressure trace.

This route finishes with the panel assembled, the firmware started, and one pressure reading in USB Serial Monitor.

1. Buy the parts on Parts to buy.
2. Print the parts on Parts to 3D print.
3. Mount, wire, and check the panel on Assembly instructions.

Next: Parts to buy.