Page Index - OpenNeptune3D/OpenNept4une GitHub Wiki
58 page(s) in this GitHub Wiki:
- Home
- Welcome to the OpenNept4une Wiki!
- Getting Started with OpenNept4une
- Table of Contents
- Prerequisites
- Flashing OpenNept4une
- Download and Preparation:
- - Neptune 4 or Neptune 4 Pro
- - Neptune 4 Plus or Neptune 4 Max
- Flash the image to the eMMC:
- Installation:
- - SSH (Requires Ethernet Connection to a router/network switch);
- - Serial (If ethernet access isn't available);
- Configure WiFi:
- Initial Configurations & Updates
- Timezone Configuration:
- Update OpenNept4une Installer & printer.cfg
- Flashing / Updating Klipper MCUs
- Updating 3rd-party modules
- Post-Installation Setup
- Update Touchscreen Display Service:
- Webcam Configuration:
- Resizing filesystem (for 32GB eMMC upgrade ONLY)
- Using Mainsail:
- LED Configuration (*for some v1.1 N4 or N4Pro users ONLY):
- Importing OrcaSlicer Profiles
- Printer Calibration & Levelling
- Safely Powering Off your Printer
- Keeping your Printer Updated
- Recovery - Back to Factory
- [Archived] v0.1.5 ‐ Guide ‐ Main Page
- Please reload this page
- Flashing the MCU without a MicroSD (Old Method)
- Please reload this page
- Hidden microSD Slot Access
- Please reload this page
- Keeping your Printer Updated
- Please reload this page
- Mainboard Versions
- Please reload this page
- Mellow Fly‐ADXL345 USB Accelerometer
- Please reload this page
- ON v0.1.7 Main Page
- Please reload this page
- Printer Calibration ‐ Klipper & OrcaSlicer
- Please reload this page
- Reverting back to Original Elegoo Firmware & Software
- Please reload this page
- Stepper Motor Versions (N4 & N4 Pro)
- Please reload this page
- Submitting Github Issues
- Please reload this page
- Updating your printer.cfg
- Please reload this page
- Using other Slicers & Profiles
- Please reload this page
- Writing OpenNep4une image without eMMC adapter
- Please reload this page