Draw Multiline

TS_CUTTER

You use this tool to create a multi-line line with a cut / crease / score segments.

This tool creates LINE entities.

 

---

Overview

Figure 1: Draw Multiline Dialog

Select Line Type

Use this set of options to specify the type of line you want to create.

 

Setting	Description
Line Type	The following line types are supported:  Crease / Score Cut / Crease Cut / Score Perforations
Rule Size	There are several rule sizes that you can select from:  3 x 3 6 x 6 9 x 9 10 x 10 12 x 12 15 x 15 18 x 18 22 x 22 25 x 25 30 x 30
Cut Length	Specify the length each cut segment.
Crease Length	Specify the length each crease segment.

Start / End Segments

Use this set of options to specify how the actual line segments are created.

 

Setting	Description
Start Segment Type	Use the drop-down list to specify the type of the first segment. Available choices are:  Cut Create
End Segment Type	Use the drop-down list to specify the type of the last segment. Available choices are:  Cut Create
Minimum Segment Length	Specify the minimum length for each segment.  This setting does not apply to the first segment.
First Segment Length	Specify the length of the first segment.
Make equal length at each end	When this setting is used the command will take the combined length of the first and last segments and then make them equal by dividing the combined length by 2.  Here is an example by by way of explanation:  Start segment is 6 units long. End segment is 10 units long. The combined length of both segments is 16 units. Therefore, the length of both segments is adjust to 8 (half of 16).  This setting overrides the First Segment Length setting.
Reverse Line	When this setting is used the command will reverse the start point / end point of each LINE in the selection set.  This setting does not apply to selected ARC entities.

 

---

Previous Topic	Next Topic