LAB 4 Class Lab, Small Enterprise - ConnorEast/Tech-Journal GitHub Wiki
Equipment used
|
|---|
Network Table used
| Vlan Name | Vlan # | Net Mask | Default Gatewat |
|---|---|---|---|
| West Clinic | 100 | 192.168.10.0/24 | 192.168.10.1 |
| West Admin | 110 | 192.168.11.0/24 | 192.168.11.1 |
| Central Clinic | 200 | 192.168.20.0/24 | 192.168.20.1 |
| Central Admin | 210 | 192.168.21.0/24 | 192.168.21.1 |
| East Clinic | 300 | 192.168.30.0/24 | 192.168.30.1 |
| East Admin | 310 | 192.168.31.0/24 | 192.168.31.1 |
| Yonder Clinic | 400 | 192.168.40.0/24 | 192.168.40.1 |
| Yonder Admin | 410 | 192.168.41.0/24 | 192.168.41.1 |
| Backbone | 50 | 192.168.50.0/24 |
Cisco Core Switch commands
|
General Notes: Do not go into startup wizard -- If there is already data on the switch, run the command ‘write erase’ then ‘reload’ >Switch[config]# hostname East-MLS > East-MLS(config)#ip routing >int vlan300 >ip address 192.168.30.1 255.255.255.0 >no shut >int vlan310 >ip address 192.168.31.1 255.255.255.0 >no shut >East-MLS(config)# vlan 300 >East-MLS(config-vlan)# name EastClinic >East-MLS(config)# vlan 310 >East-MLS(config-vlan)# name EastAdmin >East-MLS(config)#interface >East-MLS(config-if)#switchport access vlan 310 >East-MLS(config-if)#switchport mode access >East-MLS(config-if)#switchport mode encapsulation dot1q >East-MLS(config-if)#switchport mode trunk |
Cisco Access Switch 1 commands
|
>Router: Enable >Switch[config]# hostname East-Clinic >eastClinic>enable >eastClinic#show run >eastClinic(config)#interface GigabitEthernet1/0/1 >eastClinic(config-if)#no switchport access vlan 300 >eastClinic(config-if)#switchport trunk encapsulation dot1q >eastClinic(config-if)#switchport mode trunk >eastClinic(config-if)#no shut >eastClinic(config-if)#exit >eastClinic(config)#interface GigabitEthernet1/0/2 >eastClinic(config-if)#switchport mode access >eastClinic(config-if)#switchport access vlan 300 >eastClinic(config-if)#no shut >eastClinic(config-if)#exit >eastClinic(config)#exit >eastClinic#copy run |
Cisco Access Switch 2 commands
|
>East-Admin>enable >East-Admin#show run >East-Admin#conf t >East-Admin(config)#interface GigabitEthernet1/0/1 >East-Admin(config-if)#no switchport access vlan 310 >East-Admin(config-if)#no switchport trunk allowed vlan 1 >East-Admin(config-if)#$llowed vlan 1,100,110,200,210,300,310,400,410 >East-Admin(config-if)#exit >East-Admin(config)#interface GigabitEthernet1/0/2 >East-Admin(config-if)#$rt trunk allowed vlan 100,110,200,210,300,310,400,410 >East-Admin(config-if)#exit >East-Admin(config)#interface GigabitEthernet1/0/1 >East-Admin(config-if)#exit >East-Admin(config)#interface GigabitEthernet1/0/2 >East-Admin(config-if)#switchport access vlan 310 >East-Admin(config-if)#no shut >East-Admin(config-if)#exit >East-Admin(config)#exit >East-Admin#show run |
