Hardware Zhilde ZLD 64EU W - xoseperez/espurna GitHub Wiki

Zhilde ZLD-64EU-W

Property Value
Build flag ZHILDE_64EU_W
Build env zhilde-64eu-w

Introduction

  • Operating Voltage: AC 100~240V 50/60Hz
  • Rated Current: 10A (2400W)
  • USB Output 5V/6A (2.4A max per port)

Flashing

The hardware is based on Tuya's TYW-E2S ESP8285 WI-FI module

Unfortunately the TYM-E2S does not expose GPIO0 on the edge connector. This pin is required to be strapped to ground to put the ESP8266/85 in bootstrap mode.

GPIO0

There is a test pad on the back of the device which needs to be temporary shorted to ground during programming. The other required pins are all available on the edge connector on the side with VCC and GND.

Note that once the espurna firmware is onboard, updates and changes can be done with the OTA feature of the firmware without physically accessing the device again.

Usage

The switches are mapped as follows:

  • Switch 1 - 3 left sockets
  • Switch 2 - 3 right sockets
  • Switch 3 - all 4 USB sockets

The button does nothing.