Hardware Jorge Garcia Wifi Relay Board - xoseperez/espurna GitHub Wiki

Jorge García Wifi Relays Board Kit

Property	Value
Manufacturer	Jorge García
Product page	https://www.tindie.com/products/jorgegarciadev/wifi--relays-board-kit
Wiki page
Build flag	`JORGEGARCIA_WIFI_RELAYS`
Voltage	5V

Introduction

TODO

Flashing

Wifi Relays Board Kit - Top view

You have all the required pins in an unpopulated header between the relays and the transformer. Solder a 4 pins male or female header here and connect it to your favorite USB-to-UART module. The VCC pin should be connected to 5V.

Press and hold the "Flash" button and then press and release the "Reset" button. You are now in flash mode and ready to upload the firmware image.

Issues

TODO

Support

If you're looking for support:

Issues: this is the most dynamic channel at the moment, you might find an answer to your question by searching open or closed issues.
Wiki pages: might not be as up-to-date as we all would like (hey, you can also contribute in the documentation!).
Gitter channel: you have better chances to get fast answers from project contributors or other ESPurna users. (also available with any Matrix client!)
Issue a question: as a last resort, you can open new question issue on GitHub. Just remember: the more info you provide the more chances you'll have to get an accurate answer.