NetFPGA 10G 10G Ethernet Interface Loopback Test - wvoice/Accelerators GitHub Wiki

loopback_test

projects/loopback_test

• NetFPGA-10G Specific cores
  • nf10_10g_interface
  • nf10_mdio
  • nf10_axis_gen_check
• Xilinx AXI Peripheral
  • axi_interconnect
  • axi_uartlite
  • axi_timebase_wdt
• Microblaze Subsystem
  • MicroBlaze
  • lmb_v10
  • lmb_bram_if_cntlr
  • bram_block
  • proc_sys_reset
  • clock_generator
• Other
  • diff_input_buf

This example project shows the usage of the 10G Ethernet interface on NetFPGA-10G board. Outside the FPGA, the interfaces are paired up using either Direct Attach cable or 10GBASE-R optical fiber. Inside the FPGA, Two packet generator/checkers are connected to two out of the four 10G interfaces while the rest two are looped back together. MicroBlaze subsystem will poll the statistics out of the packet generator/checkers and output them through the UART interface.

1. Build the bitfile. Please read the README under projects/loopback_test/ for detailed instructions. This process will take up to an hour. However, you may skip this step if you have a pre-built bitfile available.
2. Connect Port 0 to Port 1, and Port 2 and Port 3 on the NetFPGA-10G board using either Direct Attach cable or 10GBASE-R optical fiber.
3. Connect UART to the serial port (RS232) on your PC. Open a terminal (PuTTY on Windows or minicom/gtkterm on Linux) and listen to your serial port.
4. Download the bitfile to the FPGA and follow the instructions on the terminal (see the screenshot below).