• Quick reference
• 2D/3D Drawings with/without heatsink
• Manual
• Connector Specification - Information within Manual

• Intel® Celeron N3550
• Intel® Pentium N4200
• Intel Atom® x7-E3950

• 2GB/4GB/8GB LPDDR4

• Intel® HD Graphics 500 for Intel® Celeron® N3350
• Intel® HD Graphics 505 for Intel® Pentium® N4200 / Intel Atom® x7-E3950

• 1 Full HDMI 1.4b – 4K (3840x2160) @ 30 hz
• 1 DisplayPort 1.2 – 4K (4096x2160) @ 60 hz
• 1 eDP display

• 32 GB / 64 GB HS400 eMMC

• 2 x GbLAN (Intel i210 AT) support TSN (for industrial SoC only)

• 3 USB 3.0 host ports (USB3.0 Type A socket)
• 1 USB 3.0 OTG port (USB3.0 Micro-B socket)**
• 2 USB 2.0 host ports (10-pin header) (from HUB)
  • Device mode is currently supported through a configuration option from the BIOS menu
  • Additional cable required to provide Type A socket for host mode

• Full-size SATA3 port (SATA 6Gb/s)

• 1 M2 E key 2230 slot (M.2 slot supports PCIe Gen.2, and 5Gbps bandwidth)
• 1 M2 M key 2280 slot
• 1 M2 B key co-lay 3042/3052 slot

The UP Squared Pro has two connectors for GPIO/peripherals:

• m10 header
• HAT connector: pin-compatible with Raspberry Pi Pin position

The M10 header has one UART (max 3Mbaud) and two USB 2 ports available through an adapter cable,

http://up-shop.org/up-peripherals/110-usb-20-pin-header-cable.html

Each of the HAT pins has a dual function, a standard GPIO in/out mode, and a function mode. On the board start, all the pin are set in function mode by default but that can be changed within the bios menu see 40-pin multi-function I/O header

• 28 GPIO-capable pins
• 2 I2C ports:
  • mode supported Standard, Fast, Fast Plus, High Speed)
• SPI0:
  • max speed 25MHZ
  • 2 Chip enable
  • supported modes 0 and 2
• SPI1:
  • max speed 25MHZ
  • 3 Chip enable
  • supported modes 0 and 2
• uart1
  • max baudrate 3Mbaud
  • hardware flow control
• 3 PWM output
• 1 i2s port

• Present

(ALTERA) Intel® MAX® 10 FPGAs 10M02 (2K gates)

• part number 10M02SCU169C8G
• exposed jtag for in-system reprogramming
• 2K gates
• https://www.altera.com/products/fpga/max-series/max-10/overview.html

• 85.60 mm × 90.0 mm x 46 mm (with passive heatsink installed)

• Without SATA hard drive/Celeron boards
  12VDC @4A 5.5/2.1 mm jack
• With SATA hard drive/Pentium boards and for full USB current capability
  12VDC @6A 5.5/2.1 mm jack

• UP Squared Pro Pinout
• UP Squared Pro Main page