How to enable and access USB 3.0 IO on CN26

Locating CN26 pin on your UP Xtreme

Please refer to the image below to identify CN26.

Pin	Signal	BIOS
26	GPIO22/SPI_1_FS1	GPIO23

To open the USB3.0 for Net Plus, you will need to change the following BIOS setting

• Press Del to enter CRB BIOS settings with password “upassw0rd”
• Main --> CRB Setup --> CRB Chipset --> PCH-IO Configuration --> PCI Express configuration --> change "Docking Port Auto Detection" from Enabled to Disabled, and set "Docking Port 5 Mulitifunction Selection" to USB.
• Press [F4] key to save the configuration and reset. Then the system will show a message "Docking Port configurations Changed", please turn off AC power, then turn ON to take effect".

Here are the settings,

Find the right mating connector and crimps for the pins, refer https://www.digikey.com/en/products/detail/jst-sales-america-inc/SHDR-30V-S-B/759926

Contact needed for each pin they for it, refer https://www.digikey.com/en/products/detail/jst-sales-america-inc/SSH-003GA-P0-2/759924