This player is for optical and audio disks. This includes:

• DVDs
• Blu-ray Disks
• CDs

The Blu-ray player is only compatible with Windows computers and should be used with the USB WriteBlocker

There are two Blu-ray players in the devices drawer, both are identical and either can be used.

• The Blu-ray player
• USB A to forked USB Micro-B and USB C cable
• USB A to micro USB cable

• To have already set-up the USB WriteBlocker according to the directions
• The Blu-ray player
• The USB A to forked USB micro B and USB C cable

1. Attach the USB micro B section of the forked end of the cable to the port on the back of the player.

   

2. Plug the other end (USB A) into the appropriate port on the Source side of the USB WriteBlocker. The player might make a whirring sound and the light on the front will flash yellow for a few seconds, this is normal.

   

1. Press the button on the front of the player. This will pop out the disk tray, but you will need to pull it out further.
2. Insert the disk into the tray, pressing carefully around the center to make sure it snaps into place.

   

3. Close the tray
4. The player will make a whirring noise again and the yellow light on the front should turn on and stay on.

1. Safely eject the disk from the computer. The tray should automatically pop out.
   • If the tray does not pop out when you eject the disk you can press on the button on the front of the player to release the tray
   • If the tray still does not open, follow the troublehooting instructions below
2. You will need to pull out the drawer again and then remove the disk by pressing the raised section in the center of the disk and popping the disk out.

1. unplug all cables and return both the player and the cables to the box.
2. Return the box to the devices drawer.

1. In the tray underneath the desk below the computer is a partially unfolded paper clip. Unplug the player from the WriteBlocker and carefully insert the unfolded end into the hole to the right of the tray on the front of the player. The drawer should now pop out. If this does not work, ask the Digital Accessions Specialist for assistance.