Ligthburn Camera Setup - timejunky/Snapmaker-Information-Pool GitHub Wiki
Attention:
Atm, I am using the Mintion LaserEngraver. BUT the wifi control works only with the GRBL driver not with the Gcode versions. As a result, you have to send G28 over the console. Home over Lightburn will only work if you connect with USB and the gCode drivers!
If this not disturbing you, then go ahead! Btw, Mintion is informed alread... They are working to solve this issues.
Advantage, I got fully control over my laser without connecting any additional cables. Furthermore, I could control outside house which I would rather not except for engraving tiles.
Follow these instructions in this case.
https://www.youtube.com/watch?v=te41Cen5meI
To cover the full height over my laser bed, I use this settings in SplitCam for the newest Wifi Laser Engraver from Mintion: 2304x1296
Attention: As mention in the Mintion guide, keep your SW at that version! I can confirm that I had issues after updating :(