Camera: Jienuo JN‐107‐AR‐E‐WIFI T31X - themactep/thingino-firmware GitHub Wiki
New procurement: be careful - there is a new version of the camera which uses a board with T41 chip which is currently not supported.
| Function | Chip |
|---|---|
| SoC | T31X |
| Sensor | SmartSens SC5235 |
| Flash | 16MB (MD25Q128SIG) |
| WiFi | RTL8731BU |
| Ethernet | 100MBit |
Sensor is 5MP(2560x1920) with 15FPS.
- Hook up UART connection. Any 3,3V adapter works.
- Connect power supply and hit Ctrl+C to interrupt U-boot. The password is HI2105CHIP.
- Back-up original firmware (see U-Boot cheat sheet).
- Flash can via tftp (see U-Boot cheat sheet).
- Important: After flashing change the FPS in /etc/prudynt.cfg to 15
1.27mm pin header for UART connection is in place.
Some possible ways to connect.
| Function | GPIO | remark |
|---|---|---|
| 11 | button | - |
| 57 | IRCUT2 | - |
| 58 | IRCUT1 | - |
| 59 | MMC card detect | - |
| 61 | WIFI power | active low |
| 62 | MMC power | active low |
- T31X ADC is connected to the LDR but currently not used by Thingino.
Detailed pictures:
Similar board in version 1.1:
Manufacturers reference: NST-IPT5X-W; As of May 2025 board can be found on the manufacturers website: https://www.enster.com/products-detail-3412275