HPC Laser Cutter Glass Engraving - swindonmakers/wiki GitHub Wiki
Engraving (flat) glass
These are my results from doing some testing on a bit of 4mm thick, cast glass measuring 100mm x 100mm.
I've included my testing SVG file if want to see it or use it.
During the test I added 2 additional boxes to the test coaster not covered in the template above but I'll explain the settings further on.
The template
The colours are, as you'd expect, for LaserCut so I could set the various speed and power settings. I did each colour one by one so I could check and observe the operation. I also adjusted the black colour so it would be engraved with the same power and speed settings for each of the colours.
The line art image is suppose to be a paper airplane, this was put on the glass using a cut
rather then using engrave
setting.