3D Printing Bearing Sizes - superjamie/lazyweb GitHub Wiki

I might redesign this at some point. For now I'll just keep a few useful shaft diameters.

Pay attention to the size for a given LMxUU bearing, not all Igus series are replacements/over/under.

6mm

Part Number	Outer Diameter	Length	Circlip Length	Note
LM6UU	12mm	19mm	13.5mm	Normal
LM6LUU	12mm	35mm	27mm	Long
RJZM-01-06	12mm	22mm	14.2mm	closed sleeved (replacement)
RJZM-02-06	12mm	22mm	N/A	compact sleeved (replacement )

8mm

Part Number	Outer Diameter	Length	Circlip Length	Note
LM8SUU	15mm	17mm	11.5mm	Short
LM8UU	15mm	24mm	17.5mm	Normal
LM8LUU	15mm	45mm	35mm	Long
RJM-01-08	16mm	25mm	16.2mm	bare pressfit (oversize)
RJZM-01-08	16mm	25mm	16.2mm	closed sleeved (oversize)
RJZM-02-08	15mm	24mm	N/A	compact sleeved (replacement)
RJZM-03-08	15.8mm	24.9mm	16.4mm	closed sleeved, self-aligning (oversize)

10mm

Part Number	Outer Diameter	Length	Circlip Length	Note
LM10UU	19mm	29mm	22mm	Normal
LM10LUU	19mm	55mm	44mm	Long
RJM-01-10	19mm	29mm	21.6mm	bare pressfit (replacement)
RJUM-01-10	19mm	29mm	21.6mm	closed sleeved (replacement)
RJUM-02-10	17mm	26mm	N/A	compact sleeved (undersize)
RJUM-03-10	19mm	28.9mm	21.8mm	closed sleeved, self-aligning (replacement)

12mm

Part Number	Outer Diameter	Length	Circlip Length	Note
LM12UU	21mm	30mm	23mm	Normal
LM12LUU	21mm	57mm	46mm	Long
RJM-01-12	22mm	32mm	22.6mm	bare pressfit (oversize)
RJUM-01-12	22mm	32mm	22.6mm	closed sleeved (oversize)
RJUM-02-12	19mm	28mm	N/A	compact sleeved (undersize)
RJUM-03-12	21.8mm	31.9mm	22.8mm	closed sleeved, self-aligning (oversize)