Wemos D1 Mini - stodev-com-br/tasmota GitHub Wiki
Flashing Wemos with Tasmota
Flashing a Wemos D1 Mini with Tasmota firmware is nearly the same as for every other device. Just connect Wemos D1 mini via USB. No action required to enter Flashmode!
Configure Tasmota for Wemos
Generic Module
In the Configuration -> Configure Module page, select Module Type: "18 Generic". After Saving the settings, the WEMOS reboots with the Generic configuration. The first time you switch to "18 Generic" you will NOT see all the options as seen in the picture below YET. You have to save "18 Generic" first and when you go there again after the reboot you get the long table where you can change all the pin's parameters. These steps are confirmed to also work with the Wemos D1 mini PRO v2.0.0.