Sonoff S26 Smart Socket - stodev-com-br/Tasmota GitHub Wiki
- Itead Product Page: http://sonoff.itead.cc/en/products/residential/sonoff-s26-smart-plug
- Itead Shop: https://www.itead.cc/sonoff-s26-wifi-smart-plug.html
Serial Connection
Please see the Hardware Preparation page for general instructions.
LED State
The S26 has a red LED connected to GPIO12 along with the relay so it's not possible to disable the power button LED entirely. Setting LedState 0 disables the blue LED when the relay is turned on and reserves it for Wi-Fi/MQTT state only.
Soldering guide
Apply rosin to shaved wires. Solder tin to the flats on the module.(First put solder tip to flat and apply tin). Gently solder the wires.
Alternative solder points available for 3V3, GND and RX on the underside of the mainboard.
| Jumper | Pin |
|---|---|
| J1 | 3V3 |
| J2 | GND |
| J3 | GPIO-12 |
| J4 | GPIO-0 |
| J5 | GPIO-13 |
| J10 | RX |
Bringing the Module into Flash Mode
- Disconnect serial programmer and power
- Press and hold the on-board button - Note: The Button on the main board is not very sensitive and must be pressed firmly.
- Connect the serial programmer (VCC, RX, TX, GND)
- Release the on-board button
The blue LED should NOT be blinking when in Flash mode.
Storage/Memory
Running Tasmota 6.1.1 the unit reports:
| Flash Size | 1024kB |
|---|---|
| Program Flash Size | 1024kB |
| Program Size | 536kB |
| Free Program Space | 464kB |
| Free Memory | 16kB |
More information
See issue #2808 for user information