Lab 4‐1: ARP Packet Tracer Lab - souderton89/Net-150 GitHub Wiki

In this session, we explored how to set up a network and assign IP addresses. To start a network, a switch is required to connect all the computers, for which we used a 2950 switch. The process involves going into the configuration on the PC, selecting 'Ethernet', and then 'IP'. Care must be taken to ensure the proper Ethernet ports are selected when connecting to the switch.

In PACKET TRACER:
Open the Command Prompt Type arp –a to see the arp table and review to see if there are any entries

xamine the address table of the switch.
Click on the switch and the select CLI. This is the Command Line Interface. You need to get to the root CLI prompt which looks like Switch# If the prompt looks like: Switch>, then type enable to enter admin mode If the prompt looks like Switch (config)# type exit to get back to the basic mode for admin