SmartPlug with POW (AISIRER, AVATAR) - seurat-atreides/Sonoff-Tasmota GitHub Wiki

I got few named Smart Plugs on Amazon with same internal parts.

AISIRER https://www.amazon.de/dp/B07DGH8Y8S

AVATAR https://www.amazon.de/dp/B07D73S72W

Device:

  • solid design with 16A Relais
  • 8 MB memory chip
  • 2 LEDs
  • POW function (unfortunately did not test yet, need help)
  • very small size, easy to disassemble
  • no need to disassemble PCBs
  • test mode works with 5 or 3.3 V (relais also works)

Disassemble

  • take off the lead with 2 screws
  • put small cross screwdriver inside 220V plug connector, there are 2 screws
  • free the antenna from plastic (no need to disconnect)
  • pull of PCB from the case

Important build flags.

  • in Platformio for tasmota flag change from 1MB to 8MB is needed, otherwise flash fails.

build_flags = ${esp82xx_defaults.build_flags} -Wl,-Teagle.flash.8m.ld

  • in Arduino IDE:

board selected - "Node MCU 1.0", standard Found how some of PINS are linked to main PCB and are easy to connect for flashing

[PCB board] https://drive.google.com/open?id=1ggvDwS6b83ZdMiPbk4BkTA-crqfShJYv

Flashing:

I've decided to use 5V - there is a painted pad on the PCB, clean it and attach 5V (see image)

  • Connect GPIO0 to GND
  • Connect RX, TX
  • Connect 5V and GND
  • Connect USB to PC, start flashing

Tasmota WEB config (Generic)

  • GPIO0 - Led1i
  • GPIO2 - Led2i
  • GPIO13 - Button1
  • GPIO15- Relais1

[webconfig] https://drive.google.com/open?id=12ysKDN6wBvdHVVC33qB3a9rpg5mzKCC7

IMPORTANT: need your help to configure properly POW module, contact me at [email protected]

Update from my side

I managed to flash two Aisirer plugs using pre build sonoff binaries, since my plugs had only 1M flash. I used 3.3V connected directly to the ESP board. I had some trouble with WLAN connectivity which caused the relais to pulse, so I switched to 2.3.0 core, which seems default again since a few releases. This runs quite well. Configure as BlitzWolf SHP(45) Module and also the power measurement is working.