GF16 - rotorflight/rotorflight GitHub Wiki

❗ This page is outdated

Rotorflight Wiki is replaced by www.rotorflight.org.

PDK (work in progress)

The JHEMCU GF16 is an F405 based FC that runs on 2S to 4S. It is a 16x16mm mounting pattern. It can also come with a 13A ESC stack.

JHEMCU-GF16 F405 hardware configuration settings

Warning!, warning!, warning!. If you dump the original as supplied betaflight configuration prior to flashing with Rotorflight it will indicate the target is JHEF405. IT ISN'T.. There are many differences between that target and your board will not work. Please load the JHEF405PRO target when Flash Rotorflight and then load your desired config file from below (motorised or servo tail). If you wish to remap your board to a different configuration using the spreadsheet use the GF16 target which is already in the spreadsheet board list.

Assignment Options

There are two assignment options for the GF16. A motorised Tail versions (MT) and a Servo Tail (ST).

JHEMCU-GF16(MT)

Motorised Tail option

Download the file below and Load config file to configure the servos and motors for the Motorised tail option.

JHEMCU GF16(MT) config file

JHEMCU-GF16(ST)

Servo Tail option

Download the file below and Load config file to configure the servos and motors for the servo tail option.

JHEMCU GF16(MT) config file

JHEMCU-GF16 Examples

M1

This folder contains config files for an OMP Hobby M1 using the JHEMCU GF16 flight controller.

This folder contains config files for an OMP Hobby M1 using the JHEMCU GF16 flight controller.

⚠️ **GitHub.com Fallback** ⚠️