This_Should_Be_Easier - rmu75/linuxcnc-wiki GitHub Wiki

---

date: '2016-06-30T03:16:13' title: This Should Be Easier

This is a list of things that are currently possible to configure, but shouldn't be this hard

1. Make LinuxCNC remember the tool in the spindle: A too-hard solution: https://forum.linuxcnc.org/forum/49-basic-configuration/31150-current-tool-number-permanent#76480

2. Jog whjle paused: A work around is the move-off program. A better solution was coded as proof of concept by Michael many years ago: https://www.youtube.com/watch?v=2wabcOH9YAA Andy apparently patched linuxcnc from machinekit at one time too: https://www.youtube.com/watch?v=mSx2zIUWVzQ