RA4M1 Clicker Board - renesas/micropython GitHub Wiki

How to use on RA4M1 Clicker board

  • Connect the P402 pin (for UART2_RX) of the RA4M1 Clicker board to the USB serial transmit pin (TX), the P401 pin (for UART2_TX) to the USB serial receive pin (RX), and the GND pin to each other, and connect the USB connector of the Window 10 PC.

    RA4M1 Clicker board USB-Serial Conversion cable
    P402 (for UART2_RX) TX
    P401 (for UART2_TX) RX
    GND GND
  • It is recognized as a USB serial device on the device manager port.

  • Some boards recognize it as a USB disk, but RA4M1 Clicker does not implement the USB disk function.

image P7

RA4M1 Clicker Pin Information

P8

MIKROBUS1 MIKROBUS1
MBAN P000 AN PWM P107 MBPWM
MBRST P407 RST INT P302 MBINT
MBSSL P103 CS RX P410 MBRX0
MBSCK P102 SCK TX P411 MBTX0
MBMISO P100 MISO SCL P205 MBSCL1
MBMOSI P101 MOSI SDA P206 MBSDA1
3.3V 3.3V 5V 5V
GND GND GND NC
HD1
GND 1
3.3V 2
P402 3
P401 4
P400 5
P502 6
P501 7
P014 8
P013 9
P012 10
Switch1 P304
Switch2 P301
LED1 P409
LED2 P408

RA4M1 Clicker Peripheral Table

Peripheral MPY Channel MCU Peripheral Feature MCU Pin Note
UART 1 SCI_0 TX P411
UART 1 SCI_0 RX P410
UART 1 SCI_0 CTS P103
UART 1 SCI_0 RTS P302
UART 2 SCI_1 TX P401 REPL Default channel
UART 2 SCI_1 RX P402
SPI 1 SPI0 MOSI P101
SPI 1 SPI0 MISO P100
SPI 1 SPI0 SCK P102
SPI CS P103 Default chip select pin. Another pin can be used.
I2C - - SCL P205 I2C feature by GPIO
I2C - - SDA P206 I2C feature by GPIO
External Pin Interrupt - IRQ5 IRQ5 P302 MBINT pin
External Pin Interrupt - IRQ5 IRQ5 P401 MBINT pin
External Pin Interrupt - IRQ6 IRQ6 P301 Switch2
External Pin Interrupt - IRQ9 IRQ9 P304 Switch 1
ADC 14, 12 bit - AN0xx AN000 P000
ADC 14, 12 bit - AN0xx AN007 P012
ADC 14, 12 bit - AN0xx AN008 P013
ADC 14, 12 bit - AN0xx AN009 P009
ADC 14, 12 bit - AN0xx AN022 P100
ADC 14, 12 bit - AN0xx AN021 P101
ADC 14, 12 bit - AN0xx AN020 P102
ADC 14, 12 bit - AN0xx AN019 P103
ADC 14, 12 bit - AN0xx AN017 P501
ADC 14, 12 bit - AN0xx AN018 P502