Specification difference between CK-RX65N v1 board and v2 board

#	Item	Change type	Content	V1 baseboard[P/N:RTK5CK65N0S04000BE]Cellular Cloud Kit(RYZ014A Pmod)	V2 baseboard[P/N:RTK5CK65N0S08001BE]Wi-Fi Cloud Kit(US159-DA16600EVZ Pmod)
1	PMOD I/F	Changed	IRQ of PMOD	Connect as IRQ	Connect as IRQ-DS (it can be used for Wake-up)
2	PMOD I/F	Changed	Change default setting on PMOD to full flow control.1. UART with full flow control.2. I2C.3. SPI.	Default: SPI/Control by either CTS or RTS for UART	Default: UART with full flow control
3	PMOD I/F	Added	UART full flow control (CTS & RTS) on Pmods	Not supported (either CTS or RTS)	Supported (it can ed changed by a jumper)
4	IIC I/F	Changed	Sensor Connection to RX65N	Sensors connect to 1 channel of IIC.All sensors are conneted to channel 0.	Sensors connect to 3 channels of IIC.Channel 0: HS3001, ICM-42605, and ICP-20100Channel 1: ZMOD4510, and ZMOD4410Channel 12: OB1203
5	IIC I/F	Added	IIC test pad (for waveform confirmation)	N/A	Supported
6	USB Serial Converter IC	Changed	USB to Serial conversion	RL78/G1C	FTDI (Improved throughput due to dropouts)
7	Sensor IC	Changed	Motion Tracking sensor	TDK 9-axis sensor (EOL)	6-axis sensor
8	Sensor IC	Changed	Barometric pressure sensor	ICP-10101	ICP-20100 w/o level shifter
9	ADC	Added	Fix short on both motion and pressure sensor on AD0 pin.Connecting pin to GND gives the desired address.	N/A	Put a resister to DNF to allow users to fit to enable if needed.
10	USB	Changed	USB connecor type for USB Serial Converter	USB micro B	USB C
11	Ether	Added	Added resistors and capacitors on Ethernet pins (TP_AP, TP_AN, TP_BP, TP_BN)	N/A	Four 9.9ohm resistors and two 100nF caps to Ethernet connection
12	Ether	Changed	RX65N GPIO port# to connect the P0/LED0 pin(for Link Status) of EtherPHY	P54 port of RX65N	PA5 port of RX65N
13	Sub Clock capacitor	Changed	Changed capacitor for X2(Sub Clock)	27pF	15pF
14	Power Supply	Added	Power Supply from VBUS of the USB Serial Converter IC	It does NOT connect the VBUS power supply from USB/SCI to the MCU line	Connect the VBUS power line from the USB Serial Converter IC
15	Others	Changed	LED2, S2, ISL8002	Power-good output of ISL8002 is not supported	Power-good output of ISL8002 is supported. Change pin assignment

Details