Vyper Bracket for Palette2 PTFE tube - rchamp26/Octoprint_AnycubicVyper GitHub Wiki

I remixed a bracket from two other models to make a bracket that fits the Vyper perfectly. The bracket includes a strain support and spot to mount the filament runout sensor in. The bracket screws in to the bolts where the filament sensor normally is. Just need to clip the bracket ear on the sensor to fit inside of the bracket and use 2 25mm m3 bolts with nuts and washers to hold in place.

Slicer settings

• .2 layer height
• 20% infill (could increase this for more strength, but seems plenty sturdy at only 20%)
• no supports
• I always use a skirt which helps prime the filament before starting the actual print

https://www.thingiverse.com/thing:5242762