PrusaSlicer Normal Config Filament Settings - rchamp26/Octoprint_AnycubicVyper GitHub Wiki

This is an example I use for Overture Matte PLA. Should be able to use for Most PLAs. I tend to adjust between 210C and 220C for most PLAs. Do your own calibration prints.

Before You Use

Make sure to

• Calibrate Esteps Teaching Tech's Printer Calibration - E-steps
• flow/Extrusion Multiplier test - Teaching Tech's Printer Calibration - Flow
• do a linear advance test (if using Community Firmware - I highly recommend)
• Temp tower

Filament

Cooling

Advanced