WM321 Camera sensor board - randomlettersandnumbers/DJI-Stuff GitHub Wiki
Table of Contents
Function
Variants
Parts
Programming
External interfaces
Service interfaces
Board view
Schematics
Function
The Camera sensor board contains a 12MPx CMOS sensor and SD-card slot for storing video or photos.
Variants
The known variants are listed below.
| Marking | Overview |
|---|---|
| P01036.02 | Used in original Phantom 3 Std |
| P01036.06 | Used in Phantom 3 SE |
Parts
| Marking | Amt. | Pkg. | Function | Specification |
|---|---|---|---|---|
| 1 | Camera sensor | |||
| WE245 TI 54K A0JP | 1 | SN74AVC8T245 8-Bit Dual-Supply Bus Transceiver With Configurable Voltage Translation and 3-State Outputs | description | |
| 25R2 | 2 | 5-lead | ||
| CEG 401 CKE9 | 1 | VSON-10 | TI TPS74701 500-mA Low-Dropout Linear Regulator With Programmable Soft-Start | description |
| M160A 15191 607AA | 1 | InvenSense accelerometer/gyroscope device (clone?) |
Programming
No programmable components exist on the board.
External interfaces
The board contains one connector:
| Marking | Overview |
|---|---|
| TODO |
Service interfaces
The following service pads exist on this board:
| Marking | Overview |
|---|---|
| TODO |
Board view
Top of a P01036.02 board:
Bottom of the P01036.02 board:
Top of another P01036.02 board:
Bottom of the P01036.02 board:
Top of P01036.06 board:
Bottom of the P01036.06 board:
Bottom of an unknown board, probably another P01036.06:
Schematics
No schematics available.