Xiaomi Redmi Note 10 5G Redmi Note 10T 5G Poco M3 Pro 5G Redmi Note 11SE 5G - phhusson/treble_experimentations GitHub Wiki

Xiaomi Redmi Note 10 5G / Redmi Note 10T 5G / Poco M3 Pro 5G / Redmi Note 11SE 5G (camellian)

Supported GSI : A/B

Architecture : ARM64

Hardware Support

Component	Comment
Camera	Front, back and auxiliary cam working. Recommended to enable "Expose Aux cameras" at Phh Treble Settings and use 3rd party GCam.
Speaker / Mic / Calls	All works, but sometimes can't switch properly from Call mode to Loudspeaker.
Bluetooth	Works, recommended to enable "Bluetooth workarounds" to Mediatek at Phh Treble Settings.
WiFi	Works.
SIM / Mobile Data / Voice	Works.
VoLTE	Works. Make sure install IMS for Mediatek and enable Force
Fingerprint	Works.
NFC	Works.
Bluetooth calls	Not Tested.
Brightness	Flickering when switching brightness. Enable "Force alternative backlight scale", "Use linear screen brightness slider", and "Allows setting to the lowest possible" at Phh Treble Settings. Worked, check out overlays hotfix below.

---

Reboot the device to apply all changes.

Tutorial

!! THIS WILL ERASE YOUR INTERNAL DATA !!

Prerequisite:

• Unlocked bootloader (obviously, duh)
• NOT ROOTED
• Fastbootd drivers (recommend to use Google USB/Xiaomi USB drivers)
• Patched vbmeta.img

How to:

1. Connect your device to PC and open command prompt
2. Reboot your device to fastboot mode by pressing Power + Volume Down button
3. Make sure you do fastboot devices first before you proceed and make sure your devices are detected on list
4. After the device is detected, then do fastboot reboot fastboot
5. Do fastboot devices and make sure your devices are detected on list and your device is on fastbootd screen
6. Execute this command below

fastboot set_active a
fastboot delete-logical-partition product
fastboot erase system

7. After erase system partition, then we flash the GSI using command below:

fastboot flash system system-(prefix)*-arm64-ab-vanilla.img (change it to gsi file that you downloaded)

If there's invalid sparse file at flashing system, just ignore.

8. After that, we must flash vbmeta with the command below

fastboot --disable-verity --disable-verification flash vbmeta (vbmeta.img mod or patch)
fastboot flash vbmeta_b (vbmeta.img mod or patch)
fastboot set_active a

9. Then we reboot the device to recovery by using fastboot reboot recovery
10. In recovery, you select the wipe data and then reboot to your system.

---

If you are rooted with Magisk, you can flash this hotfix module for brightness and overlays. If not, enable "Force alternative backlight scale", "Use linear screen brightness slider", and "Allows setting to the lowest possible" at Phh Treble Settings.

Tested Roms

Feel free to contribute here if you ever tested other GSIs

• NaokoShoto - camellian @ PixelExperience_arm64-ab-12.0-20211218 (Ponces build)
• KucingAbu - camellian @ ProjectElixir-3.6-gsi-13.0-20230223-1108-OFFICIAL (KrutosX & Lynix build)
• NaokoShoto - camellian @ evolutionX_arm64-ab-vndklite-7.6-unofficial-20230216 (Ponces build)