telemetry_port_speed_test - openconfig/featureprofiles GitHub Wiki

gNMI-1.5: Telemetry: Port Speed Test

Summary

Validate port speed telemetry used by controller infrastructure.

Procedure

  • For each port speed to be supported by the device:
    • Connect single port to ATE, validate that the port speed (/interfaces/interface/ethernet/state/port-speed) and negotiated port speed (/interfaces/interface/ethernet/state/negotiated-port-speed, when auto-negotiate is enabled) reported in telemetry match the expected port speed.
    • Turn port down at ATE, validate that operational status of the port is reported as down.
  • For each port speed to be supported by the device:
    • Connect N ports between ATE and DUT configured as part of a LACP bundle. Validate /interfaces/interface/aggregation/state/lag-speed is reported as N*port speed.
    • Disable each port at ATE and determine that the effective speed is reduced by the expected amount.
    • Turn ports sequentially up at the ATE, and determine that the effective speed is increased as expected.

Canonical OC

{
  "interfaces": {
    "interface": [
      {
        "config": {
          "description": "port1",
          "enabled": true,
          "name": "eth1",
          "type": "ethernetCsmacd"
        },
        "ethernet": {
          "config": {
            "aggregate-id": "Port-Channel1",
            "auto-negotiate": true,
            "port-speed": "SPEED_100GB"
          },
          "state": {
            "auto-negotiate": true,
            "negotiated-port-speed": "SPEED_100GB",
            "port-speed": "SPEED_100GB"
          }
        },
        "name": "eth1",
        "state": {
          "oper-status": "UP"
        }
      },
      {
        "aggregation": {
          "config": {
            "lag-type": "LACP",
            "min-links": 1
          },
          "state": {
            "lag-speed": 200000
          }
        },
        "config": {
          "description": "LAG To ATE",
          "enabled": true,
          "name": "Port-Channel1",
          "type": "ieee8023adLag"
        },
        "name": "Port-Channel1"
      }
    ]
  }
}

OpenConfig Path and RPC Coverage

The below yaml defines the OC paths intended to be covered by this test. OC paths used for test setup are not listed here.

TODO(OCPATHS): Config paths TBD

paths:
  ## Config Paths ##
  # TBD

  ## State Paths ##
  /interfaces/interface/state/oper-status:
  /interfaces/interface/ethernet/state/port-speed:
  /interfaces/interface/ethernet/state/negotiated-port-speed:
  /interfaces/interface/aggregation/state/lag-speed:

rpcs:
  gnmi:
    gNMI.Subscribe:

Minimum DUT platform requirement

vRX

⚠️ **GitHub.com Fallback** ⚠️