system_ntp_test - openconfig/featureprofiles GitHub Wiki

OC-26.1: Network Time Protocol (NTP)

Summary

Ensure DUT can be configured as a Network Time Protocol (NTP) client.

Procedure

  • For the following cases, enable NTP on the DUT and validate telemetry reports the servers are configured:
    • 4x IPv4 NTP server in default VRF
    • 4x IPv6 NTP server in default VRF
    • 4x IPv4 & 4x IPv6 NTP server in default VRF
    • 4x IPv4 NTP server in non-default VRF
    • 4x IPv6 NTP server in non-default VRF
    • 4x IPv4 & 4x IPv6 NTP server in non-default VRF

Note: [TODO]the source address of NTP need to be specified

OpenConfig Path and RPC Coverage

The below yaml defines the OC paths intended to be covered by this test. OC paths used for test setup are not listed here.

TODO(OCPATH): Populate path from test already written.

paths:
  ## Config paths
  /system/ntp/config/enabled:
  /system/ntp/servers/server/config/address:
  #[TODO]/system/ntp/servers/server/config/source-address:
  /system/ntp/servers/server/config/network-instance:

  ## State paths
  /system/ntp/servers/server/state/address:
  #[TODO]/system/ntp/servers/server/state/source-address:
  #[TODO]/system/ntp/servers/server/state/port:
  /system/ntp/servers/server/state/network-instance:

rpcs:
  gnmi:
    gNMI.Set:
    gNMI.Subscribe:
⚠️ **GitHub.com Fallback** ⚠️