static_lsp_test - openconfig/featureprofiles GitHub Wiki

TE-9.2: MPLS based forwarding Static LSP

Summary

Validate static lsp functionality.

Procedure

  • Create topology ATE1–DUT1-ATE2
  • Enable MPLS forwarding and create egress static LSP to pop the label and forward to ATE2:
  • Match incoming label (1000001)
  • Set IP next-hop
  • Set egress interface
  • Set the action to pop label
  • Start 2 traffic flows with specified MPLS tags IPv4-MPLS[1000002]-MPLS[1000001]
  • Verify that traffic is received at ATE2 with MPLS label [1000001] removed

OpenConfig Path and RPC Coverage

The below yaml defines the OC paths intended to be covered by this test. OC paths used for test setup are not listed here.

paths:
  ## Config paths
  /network-instances/network-instance/mpls/lsps/static-lsps/static-lsp/egress/config/next-hop:
  /network-instances/network-instance/mpls/lsps/static-lsps/static-lsp/egress/config/incoming-label:
  /network-instances/network-instance/mpls/lsps/static-lsps/static-lsp/egress/config/push-label:

  ## State paths
  /network-instances/network-instance/mpls/lsps/static-lsps/static-lsp/egress/state/next-hop:
  /network-instances/network-instance/mpls/lsps/static-lsps/static-lsp/egress/state/incoming-label:

rpcs:
  gnmi:
    gNMI.Set:
    gNMI.Subscribe:
⚠️ **GitHub.com Fallback** ⚠️