lldp_packetout_test - openconfig/featureprofiles GitHub Wiki

P4RT-7.2: LLDP: PacketOut

Summary

Verify that LLDP packets can be sent by the controller.

Procedure

  • Connect ATE port-1 to DUT port-1, and ATE port-2 to DUT port-2.
  • Disable on-box processing of LLDP.
  • Enable the P4RT server on the device.
  • Connect a P4RT client and configure the forwarding pipeline. Install the P4RT table entry required for LLDP.
  • Send an LLDP packet from the client with egress_singleton_port set to one of the connected interfaces.
  • Verify that the LLDP packet is received on the ATE port connected to the indicated interface.

OpenConfig Path and RPC Coverage

paths:
  /components/component/integrated-circuit/config/node-id:
    platform_type: [INTEGRATED_CIRCUIT]
  /interfaces/interface/config/description:
  /interfaces/interface/config/enabled:
  /interfaces/interface/config/id:
  /interfaces/interface/config/name:
  /interfaces/interface/config/type:
  /interfaces/interface/subinterfaces/subinterface/ipv4/addresses/address/config/prefix-length:
  /interfaces/interface/subinterfaces/subinterface/ipv4/config/enabled:
  /lldp/config/enabled:
rpcs:
  gnmi:
    gNMI.Get:
    gNMI.Set:
    gNMI.Subscribe:

vRX if the vendor implementation supports FIB-ACK simulation, otherwise FFF.

⚠️ **GitHub.com Fallback** ⚠️