google_discovery_protocol_packetout_lag_test - openconfig/featureprofiles GitHub Wiki
Verify that GDP packets can be sent by the controller.
- Configure two lag bundles between ATE and DUT with one member port in each of the LAG. A[ATE:LAG1] <---> B[LAG1:DUT]; C[ATE:LAG2] <---> D[LAG2:DUT];
- Enable the P4RT server on the device.
- Connect two P4RT clients in a master/secondary configuration.
- Configure the forwarding pipeline and install the P4RT table entry required for GDP.
- Send a GDP packet from the master with egress_singleton_port set to one of the connected interfaces.
- Verify that the GDP packet is received on the ATE port connected to the indicated interface.
- Repeat sending the packet in the same way but from the secondary connection.
- Verify that the packet is not received on the ATE.
The below yaml defines the OC paths intended to be covered by this test.
paths:
## Config parameter coverage
/interfaces/interface/ethernet/config/port-speed:
/interfaces/interface/ethernet/config/duplex-mode:
/interfaces/interface/ethernet/config/aggregate-id:
/interfaces/interface/aggregation/config/lag-type:
/network-instances/network-instance/vlans/vlan/state/vlan-id:
## Telemetry parameter coverage
/lacp/interfaces/interface/members/member/state/counters/lacp-in-pkts:
/lacp/interfaces/interface/members/member/state/counters/lacp-out-pkts:
/lacp/interfaces/interface/members/member/state/counters/lacp-rx-errors:
/lacp/interfaces/interface/name:
/lacp/interfaces/interface/state/name:
/lacp/interfaces/interface/members/member/interface:
/lacp/interfaces/interface/members/member/state/interface:
## Protocol/RPC Parameter Coverage
rpcs:
gnmi:
gNMI.Subscribe:
gNMI.Set:
gNMI.Get:- FFF