Library Support

Version v1.08 and above also support the DOGXL160 display.

Introduction The DOGXL160 has 160x104 pixel. Each pixel can have one of 4 different values: Pixel off (value 0) Light gray (value 1) Dark gray (value 2) Black (value 3) BW and GR Modes For the DOGXL160 display, two different modes are available (See also the install wiki page for configuration of the library): `DOGXL160_HW_BW`: A black and white mode, which does not support gray levels. It is faster than `DOGXL160_HW_GR` mode. Only values 0 and 3 can be used. `DOGXL160_HW_GR`: Supports gray levels (all pixel values) for the DOGXL160

Frames per Second

The following table gives an overview on the frame rates with the DOGXL160 display. Measure condition: End of level 1 in spacetrash (Arduino Uno).

Mode	DOG_DOUBLE_MEMORY	DOG_REVERSE	Frames per Second
DOGXL160_HW_GR	no	no REV	14 FPS
DOGXL160_HW_GR	no	with REV	14 FPS
DOGXL160_HW_GR	yes	no REV	18 FPS
DOGXL160_HW_GR	yes	with REV	17 FPS
DOGXL160_HW_BW	no	no REV	19 FPS
DOGXL160_HW_BW	no	with REV	19 FPS
DOGXL160_HW_BW	yes	no REV	21 FPS
DOGXL160_HW_BW	yes	with REV	21 FPS

A new Arduino compatible shield with the DOGXL160 display will be documented here: http://schmelle2.de/wp/arduino/shields/dogxl160-shield