Hardware list

The hardware list is shown in the figure below.

Phase line

1. The resistance of the motor phase A (A+/A-) is about 5.0Ω.

   The resistance of the motor phase B (B+/B-) is about 5.0Ω.

   Important note: please confirm the phase A and phase B of the motor by a multimeter , as shown below.

   

   

   If the motor phase is wrong，The screen will always show “Phase Line Error！”, please power off and adjust the motor wiring sequence（A+ A- B+ B-）.

2. If the sequence of your motor is different from the 4pin motor cable, please adjust it by yourself. Motor cable wiring sequence adjustment method：

   ①　Poking the end of the stub 6P with toothpicks/tweezers.

   ②　Plugging it back in according to the other motor line sequence in the picture.

   

Install the motor

1. Fix the magnet：

   ① glue：3M glue (preferred), 502 glue, etc.

   ② The magnet should stick to the middle of the motor shaft as near as possible, the magnet shoule be laid flat.

   ③ Make sure the magnet is firmly attached.

   

2. Put the gasket on the screw holes. The default size of the gasket is 3×7×2 mm.

3. Fix the PCBA board

4. Screw the screws (The length of screws is 40mm.)

5. Plug in the 4pin motor cable.

6. The motor has been installed, as shown below.