Clibrate and Run the motor - makerbase-mks/MKS-SERVO42C GitHub Wiki
Clibrate the motor
Select Cal in the menu,wait 1-2minutes for calibration complete.
Note:The motor does not carry a load.
Run the motor
-
MKS Gen_L V1.x mainboard screen operation description:
Press the big knob:Enter settings/selection
Turn the big knob right:Option down
Turn the big knob left:Option up
STOP knob:Reset
-
Press the big knob on screen mainbard to perform menu operations ,as shown in the figure below.
-
Select“Motion”,as shown in the figure below.
-
Select“Move Axis”->“Move X”->“Move 10mm”,as shown in the figure below.
-
Turn the big knob right,the position value increases and the motor rotates in the forward direction,as shown in the figure below.
-
Turn the big knob left,the position value decreases and the motor rotates in the reverse direction,as shown in the figure below.