Hardware Wiring - makerbase-mks/MKS-DLC32 GitHub Wiki
Please according to the wiring manual:https://github.com/makerbase-mks/MKS-DLC32/blob/main/doc/DLC32%20wiring%20manual.pdf
Supplementary note:
- About air assist and cold water assist
- Both air and cold water assist use SCL pins as signal control pins.Hardware wiring please refer to:
( M7/M8——>>Pin SCL outputs high level 3.3V; M9M7/M8——>>Pin SCL outputs low level 0V )And select mosfet switch module according to signal pin SCL output voltage - In laser firmware, air assist (M7) is effective; Cold water assist (M8) is available in CNC firmware
- Both air and cold water assist use SCL pins as signal control pins.Hardware wiring please refer to:
- About laser power external connection
- If your laser power exceeds 25W, then the laser power supply needs to be connected externally. The power of the power supply must meet the requirements of your laser head. At the same time, the ground wire of the power supply needs to be connected to the ground of the motherboard, and the signal line is connected to the TTL signal pin of the motherboard -- S