Board: CC2538DK - jonas-rem/RIOT GitHub Wiki
Overview
The CC2538DK is Texas Instruments' developer kit for the CC2538 SoC MCU, which combines an ARM Cortex-M3 microcontroller with an IEEE802.15.4 radio.
Hardware
| MCU | CC2538SF53 |
|---|---|
| Family | ARM Cortex-M3 |
| Vendor | Texas Instruments |
| RAM | 32Kb |
| Flash | 512Kb |
| Frequency | 32MHz |
| FPU | no |
| Timers | 4 |
| ADCs | 1x 12-bit (8 channels) |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 1 |
| Vcc | 2V - 3.6V |
| Datasheet | Datasheet (pdf file) |
| Reference Manual | Reference Manual |
Flashing and Debugging
By default, RIOT will attempt to flash the MCU via the USB UART using a Python script named cc2538-bsl. Hold down the SELECT pushbutton while pressing RESET to activate the MCU's internal bootloader, then run:
make flash
Some Linux machines may not recognize the CC2538DK's vendor and product ID automatically. If a /dev/ttyUSBx device does not appear, try specifying these codes to the FTDI driver manually:
echo 0403 a6d1 > /sys/bus/usb-serial/drivers/ftdi_sio/new_id
RIOT will use /dev/ttyUSB1 by default, but if the UART is given a different device name, you can specity it to RIOT using the PORT variable:
make PORT=/dev/ttyUSB2 flash
To flash using a Segger JLink JTAG adapter you need to install Segger's JLinkExe tool, then specify PROGRAMMER=jlink when flashing:
make PROGRAMMER=jlink flash