Encoder_(SKU__FIT0186) - jimaobian/DFRobotWiki GitHub Wiki

Introduction

This is a Gear Motor w/Encoder, model No.GB37Y3530-12V-251R. It is a powerful 12V motor with a 43.7:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 64 counts per revolution of the motor shaft, which corresponds to 2797 counts per revolution of the gearbox’s output shaft. These units have a 0.61" long, 6 mm-diameter D- shaped output shaft. This motor is intended for use at 12V, though the motor can begin rotating at voltages as low as 1V. The face plate has six mounting holes evenly spaced around the outer edge threaded for M3 screws. These mounting holes form a regular hexagon and the centers of neighboring holes are 15.5 mm apart. This motor is an ideal option for your mobile robot project.

Warning: Do not screw too far into the mounting holes as the screws can hit the gears. Manufacturer recommends screwing no further than 3mm (1/8") into the screw hole.

Specification

• Gear ratio: 43.8:1
• No-load speed: 251 + 10% RPM
• No-load current: 350 mA
• Start Voltage: 1.0 V
• Stall Torque: 18 Kg.com
• Stall Current: 7 A
• Insulation resistance: 20 M Ω
• EncoderOperating Voltage: 5 V
• Encoder type: Hall
• Encoder Resolution: 16CPR(motor shaft)/700CPR(gearbox shaft)
• Weight: 205g

Encoder Diagram

====Diagram for UNO====

====Interrupt Port with Different Board====

***Notcie:***attachInterrupt() for example,with uno board, you want to use interrupt port 0(int.0). you should connect digital pin 2 with the board. so, the following code is only used in uno and mega2560. if you want to use Leonardo or Romeo, you should change digital pin 3 instead of digital pin 2.

See the link for detail http://arduino.cc/en/Reference/AttachInterrupt

Encoder Sample Code

//The sample code for driving one way motor encoder
const byte encoder0pinA = 2;//A pin -> the interrupt pin 0
const byte encoder0pinB = 4;//B pin -> the digital pin 4
byte encoder0PinALast;
int duration;//the number of the pulses
boolean Direction;//the rotation direction


void setup()
{
  Serial.begin(57600);//Initialize the serial port
  EncoderInit();//Initialize the module
}

void loop()
{
  Serial.print("Pulse:");
  Serial.println(duration);
  duration = 0;
  delay(100);
}

void EncoderInit()
{
  Direction = true;//default -> Forward
  pinMode(encoder0pinB,INPUT);
  attachInterrupt(0, wheelSpeed, CHANGE);
}

void wheelSpeed()
{
  int Lstate = digitalRead(encoder0pinA);
  if((encoder0PinALast == LOW) && Lstate==HIGH)
  {
    int val = digitalRead(encoder0pinB);
    if(val == LOW && Direction)
    {
      Direction = false; //Reverse
    }
    else if(val == HIGH && !Direction)
    {
      Direction = true;  //Forward
    }
  }
  encoder0PinALast = Lstate;

  if(!Direction)  duration++;
  else  duration--;
}

shopping 12v dc motor 251rpm w/encoder (sku: fit0186) category: Product Manual category: FIT Series category: Motor

category: Diagram category: DFRobot