IDE Setup TBD

Github Contributions TBD

Hardware Setup for Development TBD

USB Power

THe board is typically powered from battery power, through J2, which is supplied from a wire soldered to the Door Ajar lamp. The board's power supplies will be enabled when ignition power is applied. For bench testing J2 also contains an ignition pin. You can supply 12V to both the Battery and Ignition pins to power the board on the bench.

Also, you can power the board through USB power by soldering jumper JP9, directly next to the USB port. You will also need to short the Battery and Inigtion pins on J2 for this to work.