01. Wiring Setup - frc2052/2052-LED-Training GitHub Wiki

To create the setup, KnightKrawler purchased these items.

• WS2812B LED strips or panels. Panels are needed for page 11.
• 3 Pin LED Connectors
• Breadboard Jumper wires
• 12v USB charger socket
• 12v to 5v Power Converter
• Spade connectors, wire, solder, heat shrink tubing
• ESP-WROOM-32 Development board. The ESP-WROOM-32 requires for you to Install these Drivers,

In previous years KnightKrawler used Arduino Uno's. However, we now use ESP-WROOM-32's.

If you are filling out a shopping list, we also used a small breadboard and some micro switches in a later lesson.

This guide was written for people that already have the LED box assembled. If you have not assembled it yet we recommend that you go to our website for more detailed instructions.

If you need help wiring up your LED box please talk with your programming captain or someone else who has worked with LEDs.

---

This is an image of the fully wired setup.

Make sure that the battery is wired up to the LED box as shown in this image.

---

This is an image of how the top of the LED box should look. Make sure that the wires are connected to the right sockets.