| 0x10000001 |
Client connected from IP
|
Notification that another client has connected to the radio |
| 0x31000001 |
Service mode enabled on remote device |
A service connection or command has been entered on the radio. Must be reset with a power cycle |
| 0xF3000001 |
The maximum number of connected clients has been reached |
No additional client connections can be made. Close a client to add an additional one |
| 0xF3000002 |
OPERATING TEMPERATURE EXCEEDED. REBOOT REQUIRED. |
The radio is shutting down to prevent thermal damage |
| 0x31000005 |
APPROACHING MAX TEMP. TAKE CORRECTIVE ACTION. |
The radio is reaching maximum operational temperature. Reduce temperature to avoid automatic shutdown |
| 0xF3000004 |
Radio internal temp sensor fault, return for service |
Internal temperature sensors are not functioning; the radio requires service to prevent thermal damage in the event of an over temperature event |
| 0xF3000005 |
Cannot connect to the same radio from the same PC |
Only one connection is allowed to an external PC for each radio |
| 0x31000002 |
Transmit slice has not been selected |
Without a transmit slice selected, the radio does not have a frequency for the transmitter. Select a slice to be the transmitter |
| 0x31000003 |
Interlock is preventing transmission |
Interlock prevention mechanisms are denying transmit. The most likely cause is an external device that is not ready such as an ATU, Amplifier or coupler |
| 0xE2000058 |
The PTT timeout timer has elapsed. Release PTT to reset. |
Push-to-talk has been pressed longer than the timer setting. Release the PTT and transmit again if required |
| 0x31000008 |
Default profile cannot be modified. |
An attempt was made to change the internal, default profile. Create a unique profile and save. |
| 0x31000008 |
Import Config failed. |
An attempt to import a configuration from disk has failed. The file is likely corrupted or the wrong type. |
| 0xF3000003 |
Excess Power Detected on Receiver (>+20 dBm), transmitter has been unkeyed and receiver disconnected to protect hardware. |
Power into the receiver exceeds thresholds set for the current hardware type |
| 0x31000009 |
ATU tune error. Max power set too low for ATU |
Increase the tune power and retry automatic tuner |
| 0x3100000A |
Cannot delete the 'Default' profile |
Create a new profile instead of attempting to delete the default profile |
