[EN] SMS Configuration to Sinotrack Devices - eusonlito/GPS-Tracker GitHub Wiki

To configure the connection to your Sinotrack device server you can do it via SMS with the following command:

804{PASSWORD} {IP/HOST} {PORT}

You can configure the connection server in the device using either the IP or a HOST that will resolve internally BUT ONLY AT THE TIME OF RECEIVING THE COMMAND, so if the server does not have a fixed IP as soon as it changes you will stop receiving data from the device.

Common Sinotrack ST-901 SMS commands

Configuring the Phone from which you can connect to the device

{PHONE}{PASSWORD} 1

Set the time zone to UTC to delegate the time adjustment to the platform.

896{PASSWORD}E00

Enable GPRS Mode

710{PASSWORD}

Configure APN Operator

803{PASSWORD} {OPERATOR}

Configure Server

804{PASSWORD} {IP/HOST} {PORT}

Configure frequency in seconds of sending position reports with the car ignition on

805{PASSWORD} {SECONDS}

Configure frequency in seconds of sending position reports with the car ignition off

809{PASSWORD} {SECONDS}

Set timeout before switching to SLEEP mode when the car is stopped

SLEEP{PASSWORD} {MINUTES}

Deactivate call in case of alarm

151{PASSWORD}

Enable Device Low Battery SMS

011{PASSWORD}

Disable Device Low Battery SMS

010{PASSWORD}

Password change

777{PASSWORD-NEW}{PASSWORD-OLD}

Device restart

RESTART

Show current configuration

RCONF