Manual Configuration info calibrate - easymetal/Korrostop4.0-EN GitHub Wiki

This screen is designed primarily for verification by support staff.

Picture

  • 1 - Previous screen
  • 2 - Measured data for conductivity sensor 1
  • 3 - Measured data for conductivity sensor 2
  • 4 - Average value of the last 5 measurements for measured data conductivity of sensor 1
  • 5 - Average value of the last 5 measurements for measured data conductivity of sensor 2
  • 6 - Flow rate measurement (flow rate in liters per minute and total quantity)
  • 7 - Water temperature and chip (electronics) temperature. The chip temperature can deviate considerably from reality (pay attention to the changes over time)
  • 8 - Shows whether PLC Channel 1 or Channel 2 are switched on or off
  • 9 - Water quality produced by the E.KO IONISER as a percentage
  • 10 - Last reported critical error
  • 11 - Current time and source from which the measured values originate (sensors / SD card sequence demo / simulator)