Configuring SerialNumberUpdateTask - dogtagpki/pki GitHub Wiki

Overview

This page describes the process to configure SerialNumberUpdateJob for Sequential Serial Numbers.

By default, the SerialNumberUpdateTask will run every 10 minutes.

Warning
 SerialNumberUpdateJob and SerialNumberUpdateTask should not be enabled at the same time.

Configuration

To change the interval, specify the following parameter in the CA’s CS.cfg:

ca.serialNumberUpdateInterval=<seconds>

If the value is 0 or negative, the task will be disabled.

See Also

Tip
 To find a page in the Wiki, enter the keywords in search field, press Enter, then click Wikis.
⚠️ **GitHub.com Fallback** ⚠️