BH1620FVC is an analog current output ambient light sensor.

Features:

• Spectral sensitivity close to human eyes sensitivity.
• Output current in proportion to brightness.
• Supply voltage operates from 2.4V to 5.5V
• Built-in shutdown function
• 3 steps controllable output current gain.
• 1.8V logic input interface
• Low sensitivity variation (+/-15%)

What		Comments
Identifier	BH1620FVC
Interface	ADC
Provides	illuminance	lux (*)
Properties	gain	0 = H-Gain mode 1 = M-Gain mode 2 = L-Gain mode
	r1	Iout R1 resistance value, in ohms. Default value is set to 5600 ohms. Please, refer to the datasheet page 4 for more information about R1.
	calibration	Calibration data +/- lux
Datasheet

• The gain must be set according to the illuminance range to be measured (datasheet page 5) through pins 3 and 4.
• Once the gain is set, the programmer must set the gain property. By default the sensor expects an H-Gain setting.
• Adjust r1 value to your needs.
• Once the r1 is set, the programmer must set the r1 property. By default the sensor expects a r1 value of 5600 ohms.
• The programmer can use the calibration property to correct sensor readings that may be influenced by the location of the sensor, such as when the sensor is mounted behind a protective glass.

(*)

-- Attach BH1620FVC sensor to an external ADC (ADS1115) / channel 0
s = sensor.attach("BH1620FVC", adc.ADS1115, 0)

-- If your gain / r1 values differ from de default values uncomment the
-- following lines and set your values
-- s:set("gain", 0)
-- s:set("r1", 5600)
-- s:set("calibration", 0)

while true do
  print(s:read("illuminance"))
  tmr.delayms(500)
end

Back to sensor list