ANALOG JOYSTICK SENSOR - chowette/Lua-RTOS-ESP32 GitHub Wiki
| What | Comments | |
|---|---|---|
| Identifier | ANALOG_JOYSTICK |  |
| Interface | 2 ADC 1 GPIO |
ADC 1: X signal ADC 2: Y signal GPIO : SW signal (switch) |
| Provides | x | -1: left movement 0: no movement 1: right movement |
| y | -1: up movement 0: no movement 1: down movement |
|
| sw | 0: switch released 1: switch pressed |
|
| Properties | none | |
| Callbacks? | yes |
- Hardware pull-ups are not required for switch.
-- Attach a joystick connected as
-- x external ADC (ADC1115) / channel 0
-- y external ADC (ADC1115) / channel 1
-- sw (switch) GPIO26
s = sensor.attach("ANALOG_JOYSTICK", adc.ADS1115, 0, adc.ADS1115, 1, pio.GPIO26)
-- Register a callback. Callback is executed when some sensor property changes.
s:callback(function(data)
if (data.x == -1) then
print("left")
elseif (data.x == 1) then
print("right")
end
if (data.y == -1) then
print("up")
elseif (data.y == 1) then
print("down")
end
if (data.sw == 1) then
print("sw on")
elseif (data.sw == 0) then
print("sw off")
end
end)Lua RTOS is free for you, but funds are required to make this possible. Feel free to donate as little or as much as you wish. Every donation is very much appreciated.
