Validate port speed telemetry used by controller infrastructure.

• For each port speed to be supported by the device:
  • Connect single port to ATE, validate that the port speed reported in telemetry is the expected port speed.
  • Turn port down at ATE, validate that operational status of the port is reported as down.
• For each port speed to be supported by the device:
  • Connect N ports between ATE and DUT configured as part of a LACP bundle. Validate /interfaces/interface/aggregation/state/lag-speed is reported as N*port speed.
  • Disable each port at ATE and determine that the effective speed is reduced by the expected amount.
  • Turn ports sequentially up at the ATE, and determine that the effective speed is increased as expected.

The below yaml defines the OC paths intended to be covered by this test. OC paths used for test setup are not listed here.

TODO(OCPATHS): Config paths TBD

paths:
  ## Config Paths ##
  # TBD

  ## State Paths ##
  /interfaces/interface/state/oper-status:
  /interfaces/interface/ethernet/state/port-speed:
  /interfaces/interface/aggregation/state/lag-speed:

rpcs:
  gnmi:
    gNMI.Subscribe:

vRX